Installing the driver locally

A locally connected machine is a machine directly attached to your computer using the cable. If your machine is attached to a network, skip the following steps below and go on to installing a network connected machine’s driver (see Advanced Guide).

[Note]

  • If you are a Macintosh or Linux operating systems user, refer to the "Installation for Macintosh" on page 90 or "Installation for Linux" on page 92.

  • The installation window in this User’s Guide may differ depending on the machine and interface in use.

  • Only use a USB cable no longer than 3 meters (118 inches).

Windows

  1. Make sure that the machine is connected to your computer and powered on.

    [Note]

    If the “Found New Hardware Wizard” appears during the installation procedure, click Cancel to close the window.

  2. Insert the supplied software CD into your CD-ROM drive.

    The software CD should automatically run and an installation window will appear.

  3. Select Install Now.

  4. Follow the instructions in the installation window.

    [Note]

    You can select the software applications in the Select Software to Install Window.